If you are planning to study Materials Science and Engineering at Abia State University located in Abia State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into ABSU.
Does Abia State University (ABSU) offer Materials Science and Engineering?
No, Abia State University does not offer Materials Science and Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Abia State University (ABSU) below to check if the Materials Science and Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Materials Science and Engineering When Accredited in Abia State University (ABSU)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Materials Science and Engineering department under Faculty of Engineering / Technology.
Any other relevant Science Subject
ABSU Cut-Off Mark for Materials Science and Engineering
The general UTME cut-off mark is 180, but due to the variation of Materials Science and Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ABSU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ABSU Science Courses with their Requirements
Plant Science and Biotechnology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Plant Science and Biotechnology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Electrical / Electronics Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Electrical / Electronics Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Architecture
SSCE Requirements
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Medicine and Surgery
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Medicine and Surgery department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Education and Biology
SSCE Requirements
To study this course, candidates seeking admission into the Education and Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Crop Production and Protection
SSCE Requirements
To study this course, candidates aspiring to gain admission into Crop Production and Protection department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology / Agricultural Science,
one Science/Social Science subject and
at least a pass in Physics.
Medical Laboratory Science
SSCE Requirements
To study this course, candidates aspiring to gain admission into Medical Laboratory Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Nigerian Tertiary Institutions Offering Materials Science and Engineering Course