If you are planning to study Mechanical and Metallurgical Engineering at Abia State University located in Abia State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into ABSU.
Does Abia State University (ABSU) offer Mechanical and Metallurgical Engineering?
No, Abia State University does not offer Mechanical and Metallurgical Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Abia State University (ABSU) below to check if the Mechanical and Metallurgical Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechanical and Metallurgical Engineering When Accredited in Abia State University (ABSU)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Mechanical and Metallurgical Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
one (1) other Science subject.
ABSU Cut-Off Mark for Mechanical and Metallurgical Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechanical and Metallurgical Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ABSU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ABSU Science Courses with their Requirements
Education and Biology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Education and Biology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Education and Physics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Education and Physics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects or NTC / NBC.
Food Science and Technology (FT)
SSCE Requirements
To study this course, candidates seeking admission into the Food Science and Technology (FT) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant subject from;
Biology / Agricultural Science, Physics, Basic Catering and Food Services, Bakery and Confectionaries,
Geography
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Geography department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other two (2) Science subjects.
Plant Science and Biotechnology
SSCE Requirements
To study this course, candidates seeking admission into the Plant Science and Biotechnology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Mechanical Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Mechanical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant Science subjects.
Building Technology (BT)
SSCE Requirements
To study this course, candidates aspiring to gain admission into Building Technology (BT) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Nigerian Tertiary Institutions Offering Mechanical and Metallurgical Engineering Course