
If you are planning to study Environmental Management and Pollution Control at Abubakar Tafawa Balewa University located in Bauchi State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into ATBU.
Does Abubakar Tafawa Balewa University (ATBU) offer Environmental Management and Pollution Control?
No, Abubakar Tafawa Balewa University does not offer Environmental Management and Pollution Control under its Faculty of Science. However, since our course list is updated regularly, you can visit the courses available at Abubakar Tafawa Balewa University (ATBU) below to check if the Environmental Management and Pollution Control course under the Faculty of Science has been updated.
Admission Requirements for Environmental Management and Pollution Control When Accredited in Abubakar Tafawa Balewa University (ATBU)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Environmental Management and Pollution Control department under Faculty of Science.
ATBU Cut-Off Mark for Environmental Management and Pollution Control
The general UTME cut-off mark is 180, but due to the variation of Environmental Management and Pollution Control cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ATBU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ATBU Science Courses with their Requirements
Electrical / Electronics Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronics Engineering department.
any other Science subject.
Education and Chemistry
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Chemistry department.
Biology and Agricultural Science.
Architecture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Metalwork Technology Education
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Metalwork Technology Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology / Agricultural Science, Physics, or Chemistry
and two (2) from General Science / Integrated Science, Technical Drawing / Fine Art, Geography, Health Science Food and Nutrition, Physical and Health Education, Auto Technical, Building, Electrical Electronic, Metal Work and Wood Work.
Computer and Communication Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Computer and Communication Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Automobile Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Automobile Engineering department.
any other Science subject.
Mechanical Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Mechanical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant Science subjects.
Nigerian Tertiary Institutions Offering Environmental Management and Pollution Control Course