If you are planning to study Electrical and Computer Engineering at Ahmadu Bello University located in Kaduna State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into ABU.
Does Ahmadu Bello University (ABU) offer Electrical and Computer Engineering?
No, Ahmadu Bello University does not offer Electrical and Computer Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Ahmadu Bello University (ABU) below to check if the Electrical and Computer Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Electrical and Computer Engineering When Accredited in Ahmadu Bello University (ABU)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Electrical and Computer Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any one other relevant subject.
ABU Cut-Off Mark for Electrical and Computer Engineering
The general UTME cut-off mark is 180, but due to the variation of Electrical and Computer Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ABU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ABU Science Courses with their Requirements
Dentistry and Dental Surgery
SSCE Requirements
To study this course, candidates aspiring to gain admission into Dentistry and Dental Surgery department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Zoology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Zoology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
two (2) other Science subject.
Architecture
SSCE Requirements
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Building
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Building department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Physiology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Physiology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Civil Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Civil Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Forestry and Wildlife Management
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Forestry and Wildlife Management department.
Further Mathematics and Statistics.
Nigerian Tertiary Institutions Offering Electrical and Computer Engineering Course