If you are planning to study Crop Production Technology at Alex Ekwueme Federal University Ndufu Alike-Ikwo located in Ebonyi State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into AE-FUNAI.
Does Alex Ekwueme Federal University Ndufu Alike-Ikwo (AE-FUNAI) offer Crop Production Technology?
No, Alex Ekwueme Federal University Ndufu Alike-Ikwo does not offer Crop Production Technology under its Faculty of Agriculture. However, since our course list is updated regularly, you can visit the courses available at Alex Ekwueme Federal University Ndufu Alike-Ikwo (AE-FUNAI) below to check if the Crop Production Technology course under the Faculty of Agriculture has been updated.
Admission Requirements for Crop Production Technology When Accredited in Alex Ekwueme Federal University Ndufu Alike-Ikwo (AE-FUNAI)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Crop Production Technology department under Faculty of Agriculture.
Biology/Agricultural Science,
one Science/Social Science subject and
at least a pass in Physics.
AE-FUNAI Cut-Off Mark for Crop Production Technology
The general UTME cut-off mark is 180, but due to the variation of Crop Production Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from AE-FUNAI Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other AE-FUNAI Science Courses with their Requirements
Botany
SSCE Requirements
To study this course, candidates aspiring to gain admission into Botany department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Architecture
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Geology and Geophysics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Geology and Geophysics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Geography
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Geography department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other two (2) Science subjects.
Education and Mathematics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Mathematics department.
one (1) other Science subject, and
any other relevant subjects.
Mechanical Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
Biology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biology department.
Mathematics / Physics and
any one other relevant subject.
Nigerian Tertiary Institutions Offering Crop Production Technology Course