If you are planning to study Dental Technology at Ambrose Alli University located in Edo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into AAU.
Does Ambrose Alli University (AAU) offer Dental Technology?
No, Ambrose Alli University does not offer Dental Technology under its Faculty of Health and Medical Sciences. However, since our course list is updated regularly, you can visit the courses available at Ambrose Alli University (AAU) below to check if the Dental Technology course under the Faculty of Health and Medical Sciences has been updated.
Admission Requirements for Dental Technology When Accredited in Ambrose Alli University (AAU)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Dental Technology department under Faculty of Health and Medical Sciences.
JAMB Subject Combination
one (1) other Science subject.
AAU Cut-Off Mark for Dental Technology
The general UTME cut-off mark is 230, but due to the variation of Dental Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from AAU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other AAU Science Courses with their Requirements
Industrial Chemistry
SSCE Requirements
To study this course, candidates aspiring to gain admission into Industrial Chemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology / Agricultural Science.
Anatomy
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Anatomy department.
Electrical and Electronics Engineering (EEE)
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Electrical and Electronics Engineering (EEE) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Education and Physics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Education and Physics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
two (2) other Science subjects or NTC / NBC.
Vocational and Technical Education
SSCE Requirements
To study this course, candidates seeking admission into the Vocational and Technical Education department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other relevant subject of specialization.
Architecture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Biochemistry
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biochemistry department.
Nigerian Tertiary Institutions Offering Dental Technology Course