If you are planning to study Glass Technology at Bayero University, Kano located in Kano State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into BUK.
Does Bayero University, Kano (BUK) offer Glass Technology?
No, Bayero University, Kano does not offer Glass Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Bayero University, Kano (BUK) below to check if the Glass Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Glass Technology When Accredited in Bayero University, Kano (BUK)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Glass Technology department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Spinning, Weaving, Surface Design and Printing, Bleaching, Dyeing and Finishing, Ceramics, Graphic Design, Graphic Printing, Decorative Painting,
Spray Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Building / Engineering Drawing, General Wood Work.
BUK Cut-Off Mark for Glass Technology
The general UTME cut-off mark is 180, but due to the variation of Glass Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from BUK Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other BUK Science Courses with their Requirements
Architecture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Biochemistry
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Biochemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Botany
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Botany department.
Anatomy
SSCE Requirements
To study this course, candidates seeking admission into the Anatomy department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Agricultural Science and Education
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Agricultural Science and Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology/Agricultural Science,
any other relevant subject.
Applied Biology
SSCE Requirements
To study this course, candidates seeking admission into the Applied Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Mathematics, Chemistry and
Health Science and Statistics.
Chemical Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Chemical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Nigerian Tertiary Institutions Offering Glass Technology Course