If you are planning to study Mechanical and Metallurgical Engineering at Bayero University, Kano located in Kano State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into BUK.
Does Bayero University, Kano (BUK) offer Mechanical and Metallurgical Engineering?
No, Bayero University, Kano does not offer Mechanical and Metallurgical Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Bayero University, Kano (BUK) below to check if the Mechanical and Metallurgical Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechanical and Metallurgical Engineering When Accredited in Bayero University, Kano (BUK)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Mechanical and Metallurgical Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
one (1) other Science subject.
BUK Cut-Off Mark for Mechanical and Metallurgical Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechanical and Metallurgical Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from BUK Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other BUK Science Courses with their Requirements
Education and Biology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Education and Biology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Chemical Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Chemical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
Architecture
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Computer Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Computer Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Civil Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Civil Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Dentistry and Dental Surgery
SSCE Requirements
To study this course, candidates aspiring to gain admission into Dentistry and Dental Surgery department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Agricultural Science and Education
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Agricultural Science and Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology/Agricultural Science,
any other relevant subject.
Nigerian Tertiary Institutions Offering Mechanical and Metallurgical Engineering Course