If you are planning to study Industrial Technology Education at Caritas University located in Enugu State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Caritas University.
Does Caritas University (CU) offer Industrial Technology Education?
No, Caritas University does not offer Industrial Technology Education under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Caritas University (CU) below to check if the Industrial Technology Education course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Industrial Technology Education When Accredited in Caritas University (CU)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Technology Education department under Faculty of Engineering / Technology.
three (3) other relevant subjects.
JAMB Subject Combination
one (1) other Science subject.
Caritas University Cut-Off Mark for Industrial Technology Education
The general UTME cut-off mark is 180, but due to the variation of Industrial Technology Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Caritas University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Caritas University Science Courses with their Requirements
Industrial Chemistry
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Chemistry department.
Biology / Agricultural Science.
Computer Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Engineering department.
Computer Science (CS)
SSCE Requirements
To study this course, candidates aspiring to gain admission into Computer Science (CS) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other Science subjects.
Mathematics With Statistics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Mathematics With Statistics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology and Additional / Further Mathematics.
Mechanical Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Mechanical Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant Science subjects.
Chemical Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Chemical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Architecture
SSCE Requirements
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Nigerian Tertiary Institutions Offering Industrial Technology Education Course