If you are planning to study Crop Production and Protection at Covenant University, Ota located in Ogun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Covenant University.
Does Covenant University, Ota (CU) offer Crop Production and Protection?
No, Covenant University, Ota does not offer Crop Production and Protection under its Faculty of Renewable and Natural Resources. However, since our course list is updated regularly, you can visit the courses available at Covenant University, Ota (CU) below to check if the Crop Production and Protection course under the Faculty of Renewable and Natural Resources has been updated.
Admission Requirements for Crop Production and Protection When Accredited in Covenant University, Ota (CU)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Crop Production and Protection department under Faculty of Renewable and Natural Resources, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology / Agricultural Science,
one Science/Social Science subject and
at least a pass in Physics.
JAMB Subject Combination
Biology / Agriculture and
Covenant University Cut-Off Mark for Crop Production and Protection
The general UTME cut-off mark is 180, but due to the variation of Crop Production and Protection cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Covenant University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Covenant University Science Courses with their Requirements
Information and Communication Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Information and Communication Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant subjects.
Industrial Mathematics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Industrial Mathematics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects.
Architecture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Electrical / Electronics Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronics Engineering department.
any other Science subject.
Industrial Physics With Renewable Energy
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Physics With Renewable Energy department.
Civil Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Civil Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Mechanical Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Mechanical Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant Science subjects.
Nigerian Tertiary Institutions Offering Crop Production and Protection Course