If you are planning to study Geology and Mining at Covenant University, Ota located in Ogun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Covenant University.
Does Covenant University, Ota (CU) offer Geology and Mining?
No, Covenant University, Ota does not offer Geology and Mining under its Faculty of Earth and Mineral Sciences. However, since our course list is updated regularly, you can visit the courses available at Covenant University, Ota (CU) below to check if the Geology and Mining course under the Faculty of Earth and Mineral Sciences has been updated.
Admission Requirements for Geology and Mining When Accredited in Covenant University, Ota (CU)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Geology and Mining department under Faculty of Earth and Mineral Sciences, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any one other relevant subject.
JAMB Subject Combination
Use of English and any three (3) of
Covenant University Cut-Off Mark for Geology and Mining
The general UTME cut-off mark is 180, but due to the variation of Geology and Mining cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Covenant University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Covenant University Science Courses with their Requirements
Architecture
SSCE Requirements
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Chemical Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Chemical Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
Building Technology (BT)
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Building Technology (BT) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Petroleum Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Petroleum Engineering department.
Computer Science (CS)
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Computer Science (CS) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other Science subjects.
Civil Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Civil Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Industrial Physics With Electronics and IT Application
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Industrial Physics With Electronics and IT Application department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Mathematics and one (1) other Science.
Nigerian Tertiary Institutions Offering Geology and Mining Course