If you are planning to study Shipping and Maritime Technology at Covenant University, Ota located in Ogun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Covenant University.
Does Covenant University, Ota (CU) offer Shipping and Maritime Technology?
No, Covenant University, Ota does not offer Shipping and Maritime Technology under its Faculty of Maritime Studies. However, since our course list is updated regularly, you can visit the courses available at Covenant University, Ota (CU) below to check if the Shipping and Maritime Technology course under the Faculty of Maritime Studies has been updated.
Admission Requirements for Shipping and Maritime Technology When Accredited in Covenant University, Ota (CU)
O’Level Requirements
To study this course, candidates seeking admission into the Shipping and Maritime Technology department under Faculty of Maritime Studies, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
one (1) other subject (not more than two (2) sittings) from:
Covenant University Cut-Off Mark for Shipping and Maritime Technology
The general UTME cut-off mark is 180, but due to the variation of Shipping and Maritime Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Covenant University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Covenant University Science Courses with their Requirements
Industrial Physics With Electronics and IT Application
SSCE Requirements
To study this course, candidates seeking admission into the Industrial Physics With Electronics and IT Application department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Mathematics and one (1) other Science.
Industrial Chemistry
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Chemistry department.
Biology / Agricultural Science.
Architecture
SSCE Requirements
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Mechanical Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
Computer Science (CS)
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Computer Science (CS) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other Science subjects.
Industrial Mathematics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Industrial Mathematics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects.
Civil Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Civil Engineering department.
Nigerian Tertiary Institutions Offering Shipping and Maritime Technology Course