If you are planning to study Polymer Technology at Cross River State Institute of Technology And Management located in Cross River State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Cross River State Institute.
Does Cross River State Institute of Technology And Management offer Polymer Technology?
No, Cross River State Institute of Technology And Management does not offer Polymer Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Cross River State Institute of Technology And Management below to check if the Polymer Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Polymer Technology When Accredited in Cross River State Institute of Technology And Management
O’Level Requirements
To study this course, candidates aspiring to gain admission into Polymer Technology department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
Cross River State Institute Cut-Off Mark for Polymer Technology
The general UTME cut-off mark is 180, but due to the variation of Polymer Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Cross River State Institute Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Cross River State Institute Science Courses with their Requirements
Agriculture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Agriculture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology / Agricultural Science,
Mathematics / Physics, and
Architecture
SSCE Requirements
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Microbiology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Microbiology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Electrical / Electronics Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Electrical / Electronics Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Computer Science (CS)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Science (CS) department.
any two (2) other Science subjects.
Physiology
SSCE Requirements
To study this course, candidates seeking admission into the Physiology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Education and Biology
SSCE Requirements
To study this course, candidates seeking admission into the Education and Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Nigerian Tertiary Institutions Offering Polymer Technology Course