If you are planning to study Industrial Technical Education at Eastern Palm University, Ogboko located in Imo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into EPU.
Does Eastern Palm University, Ogboko (EPU) offer Industrial Technical Education?
No, Eastern Palm University, Ogboko does not offer Industrial Technical Education under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Eastern Palm University, Ogboko (EPU) below to check if the Industrial Technical Education course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Industrial Technical Education When Accredited in Eastern Palm University, Ogboko (EPU)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Technical Education department under Faculty of Engineering / Technology.
Mathematics / Physics and
any other three (3) relevant subjects.
EPU Cut-Off Mark for Industrial Technical Education
The general UTME cut-off mark is 180, but due to the variation of Industrial Technical Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from EPU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other EPU Science Courses with their Requirements
Architecture
SSCE Requirements
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Plant Science and Biotechnology
SSCE Requirements
To study this course, candidates seeking admission into the Plant Science and Biotechnology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Statistics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Statistics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant subject.
Physics Electronics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Physics Electronics department.
Chemistry, Mathematics and
any other Science subject from
Further Mathematics and Biology or Agricultural Science.
Education and Physics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Education and Physics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects or NTC / NBC.
Microbiology
SSCE Requirements
To study this course, candidates seeking admission into the Microbiology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biochemistry
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Biochemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Nigerian Tertiary Institutions Offering Industrial Technical Education Course