If you are planning to study Mechatronics and System Engineering at Eastern Palm University, Ogboko located in Imo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into EPU.
Does Eastern Palm University, Ogboko (EPU) offer Mechatronics and System Engineering?
No, Eastern Palm University, Ogboko does not offer Mechatronics and System Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Eastern Palm University, Ogboko (EPU) below to check if the Mechatronics and System Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechatronics and System Engineering When Accredited in Eastern Palm University, Ogboko (EPU)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Mechatronics and System Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
EPU Cut-Off Mark for Mechatronics and System Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechatronics and System Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from EPU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other EPU Science Courses with their Requirements
Architecture
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Education and Mathematics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Education and Mathematics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
one (1) other Science subject, and
any other relevant subjects.
Education and Chemistry
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Chemistry department.
Biology and Agricultural Science.
Animal and Environmental Biology
SSCE Requirements
To study this course, candidates seeking admission into the Animal and Environmental Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
two (2) other Science subject.
Physics
SSCE Requirements
To study this course, candidates seeking admission into the Physics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Chemistry, Mathematics and
any other Science subject from
Biology / Agricultural Science.
Plant Science and Biotechnology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Plant Science and Biotechnology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Education and Physics
SSCE Requirements
To study this course, candidates seeking admission into the Education and Physics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
two (2) other Science subjects or NTC / NBC.
Nigerian Tertiary Institutions Offering Mechatronics and System Engineering Course