If you are planning to study Electronics and Computer Technology at ECWA Bingham University located in Nasawara State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Bingham University.
Does ECWA Bingham University (BU) offer Electronics and Computer Technology?
No, ECWA Bingham University does not offer Electronics and Computer Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at ECWA Bingham University (BU) below to check if the Electronics and Computer Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Electronics and Computer Technology When Accredited in ECWA Bingham University (BU)
O’Level Requirements
To study this course, candidates seeking admission into the Electronics and Computer Technology department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Bingham University Cut-Off Mark for Electronics and Computer Technology
The general UTME cut-off mark is 180, but due to the variation of Electronics and Computer Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Bingham University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Bingham University Science Courses with their Requirements
Anatomy
SSCE Requirements
To study this course, candidates seeking admission into the Anatomy department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Landscape Architecture
SSCE Requirements
To study this course, candidates aspiring to gain admission into Landscape Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any one (1) relevant subject from:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics,
Introduction to Building Construction, Bricklaying/Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design,
Wall Hanging, Colour Mixing/Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
Environmental Management
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Environmental Management department.
any other four (4) relevant subjects plus a pass in English Language.
Industrial Mathematics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Industrial Mathematics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
two (2) other Science subjects.
Biology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Biology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Mathematics / Physics and
any one other relevant subject.
Medicine and Surgery
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Medicine and Surgery department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Architecture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Nigerian Tertiary Institutions Offering Electronics and Computer Technology Course