If you are planning to study Mechanical and Metallurgical Engineering at ECWA Bingham University located in Nasawara State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Bingham University.
Does ECWA Bingham University (BU) offer Mechanical and Metallurgical Engineering?
No, ECWA Bingham University does not offer Mechanical and Metallurgical Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at ECWA Bingham University (BU) below to check if the Mechanical and Metallurgical Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechanical and Metallurgical Engineering When Accredited in ECWA Bingham University (BU)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Mechanical and Metallurgical Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
one (1) other Science subject.
Bingham University Cut-Off Mark for Mechanical and Metallurgical Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechanical and Metallurgical Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Bingham University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Bingham University Science Courses with their Requirements
Environmental Management
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Environmental Management department.
any other four (4) relevant subjects plus a pass in English Language.
Computer Science (CS)
SSCE Requirements
To study this course, candidates seeking admission into the Computer Science (CS) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other Science subjects.
Mathematics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Mathematics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant subjects.
Public Health
SSCE Requirements
To study this course, candidates seeking admission into the Public Health department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Radiography and Radiation Science
SSCE Requirements
To study this course, candidates aspiring to gain admission into Radiography and Radiation Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Computer Science and Information Science
SSCE Requirements
To study this course, candidates seeking admission into the Computer Science and Information Science department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other two (2) Science subjects.
Landscape Architecture
SSCE Requirements
To study this course, candidates aspiring to gain admission into Landscape Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any one (1) relevant subject from:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics,
Introduction to Building Construction, Bricklaying/Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design,
Wall Hanging, Colour Mixing/Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
Nigerian Tertiary Institutions Offering Mechanical and Metallurgical Engineering Course