If you are planning to study Metallurgical and Material Engineering at ECWA Bingham University located in Nasawara State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Bingham University.
Does ECWA Bingham University (BU) offer Metallurgical and Material Engineering?
No, ECWA Bingham University does not offer Metallurgical and Material Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at ECWA Bingham University (BU) below to check if the Metallurgical and Material Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Metallurgical and Material Engineering When Accredited in ECWA Bingham University (BU)
O’Level Requirements
To study this course, candidates seeking admission into the Metallurgical and Material Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
one other Science subject.
Bingham University Cut-Off Mark for Metallurgical and Material Engineering
The general UTME cut-off mark is 180, but due to the variation of Metallurgical and Material Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Bingham University Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Bingham University Science Courses with their Requirements
Landscape Architecture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Landscape Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any one (1) relevant subject from:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics,
Introduction to Building Construction, Bricklaying/Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design,
Wall Hanging, Colour Mixing/Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
Computer Science and Information Science
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Science and Information Science department.
any other two (2) Science subjects.
Medical Laboratory Science
SSCE Requirements
To study this course, candidates aspiring to gain admission into Medical Laboratory Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Computer Science (CS)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Science (CS) department.
any two (2) other Science subjects.
Pharmacy
SSCE Requirements
To study this course, candidates aspiring to gain admission into Pharmacy department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Botany
SSCE Requirements
To study this course, candidates seeking admission into the Botany department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Microbiology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Microbiology department.
Nigerian Universities Offering Metallurgical and Material Engineering Course