If you are planning to study Orthopaedic and Plaster Technology at Enville Institute of Management and Technology Polytechnic located in Lagos State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into EIMTP.
Does Enville Institute of Management and Technology Polytechnic (EIMTP) offer Orthopaedic and Plaster Technology?
No, Enville Institute of Management and Technology Polytechnic does not offer Orthopaedic and Plaster Technology under its Faculty of Allied Health Sciences. However, since our course list is updated regularly, you can visit the courses available at Enville Institute of Management and Technology Polytechnic (EIMTP) below to check if the Orthopaedic and Plaster Technology course under the Faculty of Allied Health Sciences has been updated.
Admission Requirements for Orthopaedic and Plaster Technology When Accredited in Enville Institute of Management and Technology Polytechnic (EIMTP)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Orthopaedic and Plaster Technology department under Faculty of Allied Health Sciences.
EIMTP Cut-Off Mark for Orthopaedic and Plaster Technology
The general UTME cut-off mark is 230, but due to the variation of Orthopaedic and Plaster Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from EIMTP Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other EIMTP Science Courses with their Requirements
Computer Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Computer Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Computer Science (CS)
SSCE Requirements
To study this course, candidates aspiring to gain admission into Computer Science (CS) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other Science subjects.
Electrical / Electronic Engineering Technology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronic Engineering Technology department.
any other Science Subject.
Nigerian Tertiary Institutions Offering Orthopaedic and Plaster Technology Course