If you are planning to study Mechatronics Engineering at Federal Polytechnic, Ede located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into EDEPOLY.
Does Federal Polytechnic, Ede (EDEPOLY) offer Mechatronics Engineering?
No, Federal Polytechnic, Ede does not offer Mechatronics Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Federal Polytechnic, Ede (EDEPOLY) below to check if the Mechatronics Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechatronics Engineering When Accredited in Federal Polytechnic, Ede (EDEPOLY)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Mechatronics Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
EDEPOLY Cut-Off Mark for Mechatronics Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechatronics Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from EDEPOLY Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other EDEPOLY Science Courses with their Requirements
Electrical / Electronics Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Electrical / Electronics Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
Civil Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Civil Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Building Technology (BT)
SSCE Requirements
To study this course, candidates aspiring to gain admission into Building Technology (BT) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Estate Management and Valuation
SSCE Requirements
To study this course, candidates seeking admission into the Estate Management and Valuation department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Economics, Arts, Physics,
Technical Drawing, Chemistry and Biology
Geological Technology
SSCE Requirements
To study this course, candidates seeking admission into the Geological Technology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) subjects from:
Nutrition and Dietetics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Nutrition and Dietetics department.
Biology/Agricultural Science.
Computer Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Computer Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Nigerian Tertiary Institutions Offering Mechatronics Engineering Course