If you are planning to study Orthopaedic and Plaster Technology at Federal Polytechnic of Oil and Gas Bonny located in Rivers State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Federal Polytechnic of Oil and Gas Bonny.
Does Federal Polytechnic of Oil and Gas Bonny offer Orthopaedic and Plaster Technology?
No, Federal Polytechnic of Oil and Gas Bonny does not offer Orthopaedic and Plaster Technology under its Faculty of Allied Health Sciences. However, since our course list is updated regularly, you can visit the courses available at Federal Polytechnic of Oil and Gas Bonny below to check if the Orthopaedic and Plaster Technology course under the Faculty of Allied Health Sciences has been updated.
Admission Requirements for Orthopaedic and Plaster Technology When Accredited in Federal Polytechnic of Oil and Gas Bonny
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Orthopaedic and Plaster Technology department under Faculty of Allied Health Sciences, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Federal Polytechnic of Oil and Gas Bonny Cut-Off Mark for Orthopaedic and Plaster Technology
The general UTME cut-off mark is 230, but due to the variation of Orthopaedic and Plaster Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Federal Polytechnic of Oil and Gas Bonny Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Federal Polytechnic of Oil and Gas Bonny Science Courses with their Requirements
Statistics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Statistics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant subject.
Electrical / Electronic Engineering Technology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Electrical / Electronic Engineering Technology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science Subject.
Computer Science (CS)
SSCE Requirements
To study this course, candidates seeking admission into the Computer Science (CS) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other Science subjects.
Industrial Safety and Environmental Engineering Technology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Safety and Environmental Engineering Technology department.
any two (2) subjects from:
Biology/Agricultural Science, Technical Drawing,
Basic Electronics / Basic Electricity,
Basic Electronics / Basic Electricity, Auto Mechanics, Metal Work,
Woodwork (for Civil Engineering Tech.),
Further Mathematics, Geography, Economics / Commerce.
Nigerian Tertiary Institutions Offering Orthopaedic and Plaster Technology Course