If you are planning to study Industrial Production Engineering at Federal University, Birnin Kebbi located in Kebbi State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into FUBK.
Does Federal University, Birnin Kebbi (FUBK) offer Industrial Production Engineering?
No, Federal University, Birnin Kebbi does not offer Industrial Production Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Federal University, Birnin Kebbi (FUBK) below to check if the Industrial Production Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Industrial Production Engineering When Accredited in Federal University, Birnin Kebbi (FUBK)
O’Level Requirements
To study this course, candidates seeking admission into the Industrial Production Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
FUBK Cut-Off Mark for Industrial Production Engineering
The general UTME cut-off mark is 180, but due to the variation of Industrial Production Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUBK Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUBK Science Courses with their Requirements
Architecture
SSCE Requirements
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Geology
SSCE Requirements
To study this course, candidates seeking admission into the Geology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other relevant subject.
Applied Geophysics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Applied Geophysics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Anatomy
SSCE Requirements
To study this course, candidates seeking admission into the Anatomy department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Geography
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Geography department.
any other two (2) Science subjects.
Building Technology (BT)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Building Technology (BT) department.
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Physiology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Physiology department.
Nigerian Tertiary Institutions Offering Industrial Production Engineering Course