If you are planning to study Textile Science and Technology at Federal University, Birnin Kebbi located in Kebbi State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into FUBK.
Does Federal University, Birnin Kebbi (FUBK) offer Textile Science and Technology?
No, Federal University, Birnin Kebbi does not offer Textile Science and Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Federal University, Birnin Kebbi (FUBK) below to check if the Textile Science and Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Textile Science and Technology When Accredited in Federal University, Birnin Kebbi (FUBK)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Textile Science and Technology department under Faculty of Engineering / Technology.
FUBK Cut-Off Mark for Textile Science and Technology
The general UTME cut-off mark is 180, but due to the variation of Textile Science and Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUBK Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUBK Science Courses with their Requirements
Mathematics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Mathematics department.
any two (2) other relevant subjects.
Statistics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Statistics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other relevant subject.
Building Technology (BT)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Building Technology (BT) department.
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Physics With Electronics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Physics With Electronics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject from Further Mathematics and Biology / Agricultural Science.
Industrial Chemistry
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Chemistry department.
Biology / Agricultural Science.
Medicine and Surgery
SSCE Requirements
To study this course, candidates aspiring to gain admission into Medicine and Surgery department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Architecture
SSCE Requirements
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Nigerian Tertiary Institutions Offering Textile Science and Technology Course