If you are planning to study Metallurgical Engineering at Federal University Ndufu Alike, Ikwo located in Ebonyi State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into FUNAI.
Does Federal University Ndufu Alike, Ikwo (FUNAI) offer Metallurgical Engineering?
No, Federal University Ndufu Alike, Ikwo does not offer Metallurgical Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Federal University Ndufu Alike, Ikwo (FUNAI) below to check if the Metallurgical Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Metallurgical Engineering When Accredited in Federal University Ndufu Alike, Ikwo (FUNAI)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Metallurgical Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
one other Science subject.
FUNAI Cut-Off Mark for Metallurgical Engineering
The general UTME cut-off mark is 180, but due to the variation of Metallurgical Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUNAI Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUNAI Science Courses with their Requirements
Fisheries and Aquaculture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Fisheries and Aquaculture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology/Agricultural Science,
Physics/Geography/Economics.
Education and Biology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Education and Biology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biotechnology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Biotechnology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Mechanical Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Mechanical Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant Science subjects.
Microbiology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Microbiology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Physiology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Physiology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Architecture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Nigerian Tertiary Institutions Offering Metallurgical Engineering Course