If you are planning to study Dentistry and Dental Surgery at Federal University of Technology Akure located in Ondo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into FUTA.
Does Federal University of Technology Akure (FUTA) offer Dentistry and Dental Surgery?
No, Federal University of Technology Akure does not offer Dentistry and Dental Surgery under its Faculty of Health and Medical Sciences. However, since our course list is updated regularly, you can visit the courses available at Federal University of Technology Akure (FUTA) below to check if the Dentistry and Dental Surgery course under the Faculty of Health and Medical Sciences has been updated.
Admission Requirements for Dentistry and Dental Surgery When Accredited in Federal University of Technology Akure (FUTA)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Dentistry and Dental Surgery department under Faculty of Health and Medical Sciences, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
JAMB Subject Combination
one (1) other Science subject.
FUTA Cut-Off Mark for Dentistry and Dental Surgery
The general UTME cut-off mark is 230, but due to the variation of Dentistry and Dental Surgery cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUTA Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUTA Science Courses with their Requirements
Cyber Security
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Cyber Security department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects.
Electrical / Electronics Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Electrical / Electronics Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
Crop, Soil and Pest Management
SSCE Requirements
To study this course, candidates seeking admission into the Crop, Soil and Pest Management department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science,
one Science/Social Science subject and
at least ‘O’ Level pass in Physics.
Forestry and Wood Technology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Forestry and Wood Technology department.
Biology / Agricultural Science,
at least ‘O’ Level pass in Physics.
Statistics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Statistics department.
any other relevant subject.
Industrial and Production Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial and Production Engineering department.
any other Science subject.
Remote Sensing and Geosciences Information System
SSCE Requirements
To study this course, candidates seeking admission into the Remote Sensing and Geosciences Information System department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further. Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall, Joinery,
Floors and Ceiling Finishing, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
Nigerian Universities Offering Dentistry and Dental Surgery Course