If you are planning to study Plant Breeding and Seed Technology at Federal University of Technology Akure located in Ondo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into FUTA.
Does Federal University of Technology Akure (FUTA) offer Plant Breeding and Seed Tech.?
No, Federal University of Technology Akure does not offer Plant Breeding and Seed Tech. under its Faculty of Agriculture. However, since our course list is updated regularly, you can visit the courses available at Federal University of Technology Akure (FUTA) below to check if the Plant Breeding and Seed Tech. course under the Faculty of Agriculture has been updated.
Admission Requirements for Plant Breeding and Seed Technology When Accredited in Federal University of Technology Akure (FUTA)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Plant Breeding and Seed Technology department under Faculty of Agriculture, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology / Agricultural Science,
one Science/Social Science subject and
at least ‘O’ Level pass in Physics.
JAMB Subject Combination
Biology / Agriculture and
FUTA Cut-Off Mark for Plant Breeding and Seed Technology
The general UTME cut-off mark is 180, but due to the variation of Plant Breeding and Seed Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUTA Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUTA Science Courses with their Requirements
Electrical / Electronics Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronics Engineering department.
any other Science subject.
Industrial Chemistry
SSCE Requirements
To study this course, candidates seeking admission into the Industrial Chemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science.
Architecture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Biology
SSCE Requirements
To study this course, candidates seeking admission into the Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Mathematics / Physics and
any one other relevant subject.
Physiology
SSCE Requirements
To study this course, candidates seeking admission into the Physiology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Animal Production and Health
SSCE Requirements
To study this course, candidates aspiring to gain admission into Animal Production and Health department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology / Agricultural Science.
Metallurgical and Material Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Metallurgical and Material Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
one other Science subject.
Nigerian Tertiary Institutions Offering Plant Breeding and Seed Tech. Course