If you are planning to study Food Science and Engineering at Federal University of Technology, Owerri located in Imo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into FUTO.
Does Federal University of Technology, Owerri (FUTO) offer Food Science and Engineering?
No, Federal University of Technology, Owerri does not offer Food Science and Engineering under its Faculty of Science. However, since our course list is updated regularly, you can visit the courses available at Federal University of Technology, Owerri (FUTO) below to check if the Food Science and Engineering course under the Faculty of Science has been updated.
Admission Requirements for Food Science and Engineering When Accredited in Federal University of Technology, Owerri (FUTO)
O’Level Requirements
To study this course, candidates seeking admission into the Food Science and Engineering department under Faculty of Science, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
FUTO Cut-Off Mark for Food Science and Engineering
The general UTME cut-off mark is 180, but due to the variation of Food Science and Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUTO Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUTO Science Courses with their Requirements
Mechanical Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
Building
SSCE Requirements
To study this course, candidates aspiring to gain admission into Building department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Medicine and Surgery
SSCE Requirements
To study this course, candidates aspiring to gain admission into Medicine and Surgery department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Polymer and Textile Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Polymer and Textile Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
Biological Science
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Biological Science department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Any other relevant Science subject.
Environmental Management
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Environmental Management department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other four (4) relevant subjects plus a pass in English Language.
Microbiology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Microbiology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Nigerian Tertiary Institutions Offering Food Science and Engineering Course