If you are planning to study Technology Education at Federal University of Technology, Owerri located in Imo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into FUTO.
Does Federal University of Technology, Owerri (FUTO) offer Technology Education?
No, Federal University of Technology, Owerri does not offer Technology Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at Federal University of Technology, Owerri (FUTO) below to check if the Technology Education course under the Faculty of Education has been updated.
Admission Requirements for Technology Education When Accredited in Federal University of Technology, Owerri (FUTO)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Technology Education department under Faculty of Education, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other three (3) relevant subjects.
JAMB Subject Combination
one (1) other Science subject.
FUTO Cut-Off Mark for Technology Education
The general UTME cut-off mark is 180, but due to the variation of Technology Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from FUTO Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other FUTO Science Courses with their Requirements
Surveying and Geoinformatics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Surveying and Geoinformatics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
Optometry
SSCE Requirements
To study this course, candidates aspiring to gain admission into Optometry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Physics, Chemistry, Biology and
Additional / Further Mathematics.
Dental Technology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Dental Technology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Statistics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Statistics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant subject.
Mechatronics Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Mechatronics Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Electrical / Electronics Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Electrical / Electronics Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
Microbiology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Microbiology department.
Nigerian Tertiary Institutions Offering Technology Education Course