If you are planning to study Mechanical and Metallurgical Engineering at Godfrey Okoye University located in Enugu State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into GOUNI.
Does Godfrey Okoye University (GOUNI) offer Mechanical and Metallurgical Engineering?
No, Godfrey Okoye University does not offer Mechanical and Metallurgical Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Godfrey Okoye University (GOUNI) below to check if the Mechanical and Metallurgical Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechanical and Metallurgical Engineering When Accredited in Godfrey Okoye University (GOUNI)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Mechanical and Metallurgical Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
one (1) other Science subject.
GOUNI Cut-Off Mark for Mechanical and Metallurgical Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechanical and Metallurgical Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from GOUNI Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other GOUNI Science Courses with their Requirements
Education and Biology
SSCE Requirements
To study this course, candidates seeking admission into the Education and Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Architecture
SSCE Requirements
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Biological Science
SSCE Requirements
To study this course, candidates aspiring to gain admission into Biological Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Any other relevant Science subject.
Education and Computer Science
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Computer Science department.
three (3) other relevant Science subjects.
Physical Science
SSCE Requirements
To study this course, candidates seeking admission into the Physical Science department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject from:
Biology or Agricultural Science.
Education and Mathematics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Education and Mathematics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
one (1) other Science subject, and
any other relevant subjects.
Education and Chemistry
SSCE Requirements
To study this course, candidates aspiring to gain admission into Education and Chemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology and Agricultural Science.
Nigerian Tertiary Institutions Offering Mechanical and Metallurgical Engineering Course