If you are planning to study Prosthesis and Orthopaedic Technology at Godfrey Okoye University located in Enugu State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into GOUNI.
Does Godfrey Okoye University (GOUNI) offer Prosthesis and Orthopaedic Technology?
No, Godfrey Okoye University does not offer Prosthesis and Orthopaedic Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Godfrey Okoye University (GOUNI) below to check if the Prosthesis and Orthopaedic Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Prosthesis and Orthopaedic Technology When Accredited in Godfrey Okoye University (GOUNI)
O’Level Requirements
To study this course, candidates seeking admission into the Prosthesis and Orthopaedic Technology department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
GOUNI Cut-Off Mark for Prosthesis and Orthopaedic Technology
The general UTME cut-off mark is 180, but due to the variation of Prosthesis and Orthopaedic Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from GOUNI Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other GOUNI Science Courses with their Requirements
Architecture
SSCE Requirements
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Physics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Physics department.
Chemistry, Mathematics and
any other Science subject from
Biology / Agricultural Science.
Physics With Electronics
SSCE Requirements
To study this course, candidates seeking admission into the Physics With Electronics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject from Further Mathematics and Biology / Agricultural Science.
Industrial Chemistry
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Chemistry department.
Biology / Agricultural Science.
Biotechnology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Biotechnology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Microbiology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Microbiology department.
Education and Biology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Education and Biology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Nigerian Tertiary Institutions Offering Prosthesis and Orthopaedic Technology Course