
If you are planning to study Dental Technology at Modibbo Adama University Of Technology located in Adamawa State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into MAUTECH.
Does Modibbo Adama University Of Technology (MAUTECH) offer Dental Technology?
No, Modibbo Adama University Of Technology does not offer Dental Technology under its Faculty of Health and Medical Sciences. However, since our course list is updated regularly, you can visit the courses available at Modibbo Adama University Of Technology (MAUTECH) below to check if the Dental Technology course under the Faculty of Health and Medical Sciences has been updated.
Admission Requirements for Dental Technology When Accredited in Modibbo Adama University Of Technology (MAUTECH)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Dental Technology department under Faculty of Health and Medical Sciences, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
JAMB Subject Combination
one (1) other Science subject.
MAUTECH Cut-Off Mark for Dental Technology
The general UTME cut-off mark is 230, but due to the variation of Dental Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from MAUTECH Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other MAUTECH Science Courses with their Requirements
Building
SSCE Requirements
To study this course, candidates aspiring to gain admission into Building department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Mathematics with Economics
SSCE Requirements
To study this course, candidates seeking admission into the Mathematics with Economics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) more pertinent subjects from Science or Social Sciences in not more than two (2) sittings.
Chemistry
SSCE Requirements
To study this course, candidates aspiring to gain admission into Chemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Forestry and Wildlife Management
SSCE Requirements
To study this course, candidates aspiring to gain admission into Forestry and Wildlife Management department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Further Mathematics and Statistics.
Medicine and Surgery
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Medicine and Surgery department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Mechanical Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Mechanical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant Science subjects.
Agricultural and Environmental Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Agricultural and Environmental Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Introduction to Agricultural Science, Materials and Workshop Process and Machining,
Tractor Layout Power Unit Under Carriage and Auto Electricity, Transmission System, Implement and Machine,
Principles of Crop Husbandry and Land Use, Materials and Workshop Processes,
Construction and Maintenance of Agricultural Machines, general Metal Work, General Wood Work and Building/Engineering Drawing.
Nigerian Tertiary Institutions Offering Dental Technology Course