
If you are planning to study Wood Production Engineering at Nnamdi Azikiwe University located in Anambra State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNIZIK.
Does Nnamdi Azikiwe University (UNIZIK) offer Wood Production Engineering?
No, Nnamdi Azikiwe University does not offer Wood Production Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Nnamdi Azikiwe University (UNIZIK) below to check if the Wood Production Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Wood Production Engineering When Accredited in Nnamdi Azikiwe University (UNIZIK)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Wood Production Engineering department under Faculty of Engineering / Technology.
any other Science subject.
UNIZIK Cut-Off Mark for Wood Production Engineering
The general UTME cut-off mark is 180, but due to the variation of Wood Production Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIZIK Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIZIK Science Courses with their Requirements
Human Kinetics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Human Kinetics department.
Health Science / Physical Education / Biology
Any other two (2) relevant subjects
Architecture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Zoology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Zoology department.
two (2) other Science subject.
Metallurgical and Material Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Metallurgical and Material Engineering department.
one other Science subject.
Parasitology and Entomology
SSCE Requirements
To study this course, candidates seeking admission into the Parasitology and Entomology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Radiography
SSCE Requirements
To study this course, candidates aspiring to gain admission into Radiography department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Geological Sciences
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Geological Sciences department.
any other relevant subject.
Nigerian Tertiary Institutions Offering Wood Production Engineering Course