If you are planning to study Surveying and Geoinformatics at Olusegun Agagu University of Science and Technology formally known as Ondo State University of Science and Technology located in Ondo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into OAUSTECH.
Does Olusegun Agagu University of Science and Technology (OAUSTECH) offer Surveying and Geoinformatics?
No, Olusegun Agagu University of Science and Technology does not offer Surveying and Geoinformatics under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Olusegun Agagu University of Science and Technology (OAUSTECH) below to check if the Surveying and Geoinformatics course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Surveying and Geoinformatics When Accredited in Olusegun Agagu University of Science and Technology (OAUSTECH)
O’Level Requirements
To study this course, candidates seeking admission into the Surveying and Geoinformatics department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
JAMB Subject Combination
Chemistry, Geography, Art, Biology and Economics.
OAUSTECH Cut-Off Mark for Surveying and Geoinformatics
The general UTME cut-off mark is 180, but due to the variation of Surveying and Geoinformatics cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from OAUSTECH Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other OAUSTECH Science Courses with their Requirements
Polymer Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Polymer Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
Mathematics
SSCE Requirements
To study this course, candidates seeking admission into the Mathematics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant subjects.
Electrical / Electronics Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronics Engineering department.
any other Science subject.
Agriculture
SSCE Requirements
To study this course, candidates seeking admission into the Agriculture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology / Agricultural Science,
Mathematics / Physics, and
Geophysics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Geophysics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Petroleum Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Petroleum Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Chemical Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Chemical Engineering department.
any other Science subject.
Nigerian Universities Offering Surveying and Geoinformatics Course