If you are planning to study Industrial Education Technology at Osun State University located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNIOSUN.
Does Osun State University (UNIOSUN) offer Industrial Education Technology?
No, Osun State University does not offer Industrial Education Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Osun State University (UNIOSUN) below to check if the Industrial Education Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Industrial Education Technology When Accredited in Osun State University (UNIOSUN)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Industrial Education Technology department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
three (3) other relevant subjects.
JAMB Subject Combination
one (1) other Science subject.
UNIOSUN Cut-Off Mark for Industrial Education Technology
The general UTME cut-off mark is 180, but due to the variation of Industrial Education Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIOSUN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIOSUN Science Courses with their Requirements
Chemical Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Chemical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Anatomy
SSCE Requirements
To study this course, candidates aspiring to gain admission into Anatomy department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Building
SSCE Requirements
To study this course, candidates seeking admission into the Building department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Mechanical Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
Electrical / Electronics Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Electrical / Electronics Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
Animal Science
SSCE Requirements
To study this course, candidates aspiring to gain admission into Animal Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology / Agric Science, and
any one from Physics, Geography or Economics.
Fisheries and Wildlife Management
SSCE Requirements
To study this course, candidates seeking admission into the Fisheries and Wildlife Management department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology/Agricultural Science,
Physics / Geography / Economics.
Nigerian Tertiary Institutions Offering Industrial Education Technology Course