If you are planning to study Gas Engineering at Redeemer's University, Nigeria located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into RUN.
Does Redeemer's University, Nigeria (RUN) offer Gas Engineering?
No, Redeemer's University, Nigeria does not offer Gas Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Redeemer's University, Nigeria (RUN) below to check if the Gas Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Gas Engineering When Accredited in Redeemer's University, Nigeria (RUN)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Gas Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
and any one Science subject.
RUN Cut-Off Mark for Gas Engineering
The general UTME cut-off mark is 180, but due to the variation of Gas Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from RUN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other RUN Science Courses with their Requirements
Physics With Electronics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Physics With Electronics department.
any other Science subject from Further Mathematics and Biology / Agricultural Science.
Biochemistry
SSCE Requirements
To study this course, candidates aspiring to gain admission into Biochemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Architecture
SSCE Requirements
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Building Technology (BT)
SSCE Requirements
To study this course, candidates aspiring to gain admission into Building Technology (BT) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Applied Geophysics
SSCE Requirements
To study this course, candidates seeking admission into the Applied Geophysics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Physiotherapy
SSCE Requirements
To study this course, candidates seeking admission into the Physiotherapy department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Actuarial Science
SSCE Requirements
To study this course, candidates seeking admission into the Actuarial Science department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other two (2) relevant subjects.
Nigerian Tertiary Institutions Offering Gas Engineering Course