
If you are planning to study Industrial and Production Engineering at Redeemer's University, Nigeria located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into RUN.
Does Redeemer's University, Nigeria (RUN) offer Industrial and Production Engineering?
No, Redeemer's University, Nigeria does not offer Industrial and Production Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Redeemer's University, Nigeria (RUN) below to check if the Industrial and Production Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Industrial and Production Engineering When Accredited in Redeemer's University, Nigeria (RUN)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial and Production Engineering department under Faculty of Engineering / Technology.
any other Science subject.
RUN Cut-Off Mark for Industrial and Production Engineering
The general UTME cut-off mark is 180, but due to the variation of Industrial and Production Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from RUN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other RUN Science Courses with their Requirements
Building Technology (BT)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Building Technology (BT) department.
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Physics With Electronics
SSCE Requirements
To study this course, candidates seeking admission into the Physics With Electronics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject from Further Mathematics and Biology / Agricultural Science.
Actuarial Science
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Actuarial Science department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other two (2) relevant subjects.
Applied Biology and Genetics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Applied Biology and Genetics department.
Physiotherapy
SSCE Requirements
To study this course, candidates seeking admission into the Physiotherapy department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Computer Science (CS)
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Computer Science (CS) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other Science subjects.
Statistics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Statistics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant subject.
Nigerian Universities Offering Industrial and Production Engineering Course