If you are planning to study Industrial Engineering at Redeemer's University, Nigeria located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into RUN.
Does Redeemer's University, Nigeria (RUN) offer Industrial Engineering?
No, Redeemer's University, Nigeria does not offer Industrial Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Redeemer's University, Nigeria (RUN) below to check if the Industrial Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Industrial Engineering When Accredited in Redeemer's University, Nigeria (RUN)
O’Level Requirements
To study this course, candidates seeking admission into the Industrial Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
RUN Cut-Off Mark for Industrial Engineering
The general UTME cut-off mark is 180, but due to the variation of Industrial Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from RUN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other RUN Science Courses with their Requirements
Microbiology
SSCE Requirements
To study this course, candidates seeking admission into the Microbiology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Architecture
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Environmental Management and Toxicology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Environmental Management and Toxicology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Nursing (Science)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Nursing (Science) department.
Applied Biology and Genetics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Applied Biology and Genetics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Mathematics
SSCE Requirements
To study this course, candidates seeking admission into the Mathematics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant subjects.
Physics With Electronics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Physics With Electronics department.
any other Science subject from Further Mathematics and Biology / Agricultural Science.
Nigerian Tertiary Institutions Offering Industrial Engineering Course