If you are planning to study Mechatronics and System Engineering at Redeemer's University, Nigeria located in Osun State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into RUN.
Does Redeemer's University, Nigeria (RUN) offer Mechatronics and System Engineering?
No, Redeemer's University, Nigeria does not offer Mechatronics and System Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Redeemer's University, Nigeria (RUN) below to check if the Mechatronics and System Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechatronics and System Engineering When Accredited in Redeemer's University, Nigeria (RUN)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Mechatronics and System Engineering department under Faculty of Engineering / Technology.
any other Science subject.
RUN Cut-Off Mark for Mechatronics and System Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechatronics and System Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from RUN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other RUN Science Courses with their Requirements
Actuarial Science
SSCE Requirements
To study this course, candidates aspiring to gain admission into Actuarial Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other two (2) relevant subjects.
Architecture
SSCE Requirements
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Building Technology (BT)
SSCE Requirements
To study this course, candidates seeking admission into the Building Technology (BT) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
Civil Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Civil Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Computer Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Engineering department.
Statistics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Statistics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant subject.
Industrial Chemistry
SSCE Requirements
To study this course, candidates aspiring to gain admission into Industrial Chemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology / Agricultural Science.
Nigerian Tertiary Institutions Offering Mechatronics and System Engineering Course