If you are planning to study Industrial Education Technology at Rivers State University formally known as Rivers State University of Science and Technology (RSUST) located in Rivers State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into RSU.
Does Rivers State University (RSU) offer Industrial Education Technology?
No, Rivers State University does not offer Industrial Education Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Rivers State University (RSU) below to check if the Industrial Education Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Industrial Education Technology When Accredited in Rivers State University (RSU)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Education Technology department under Faculty of Engineering / Technology.
three (3) other relevant subjects.
JAMB Subject Combination
one (1) other Science subject.
RSU Cut-Off Mark for Industrial Education Technology
The general UTME cut-off mark is 180, but due to the variation of Industrial Education Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from RSU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other RSU Science Courses with their Requirements
Education and Mathematics
SSCE Requirements
To study this course, candidates seeking admission into the Education and Mathematics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
one (1) other Science subject, and
any other relevant subjects.
Physics
SSCE Requirements
To study this course, candidates aspiring to gain admission into Physics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Chemistry, Mathematics and
any other Science subject from
Biology / Agricultural Science.
Food Science and Technology (FT)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Food Science and Technology (FT) department.
any two (2) other relevant subject from;
Biology / Agricultural Science, Physics, Basic Catering and Food Services, Bakery and Confectionaries,
Environmental Management
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Environmental Management department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other four (4) relevant subjects plus a pass in English Language.
Forestry and Wildlife
SSCE Requirements
To study this course, candidates aspiring to gain admission into Forestry and Wildlife department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Further Mathematics and Statistics.
Agricultural Extension and Rural Development
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Agricultural Extension and Rural Development department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Chemistry, Biology / Agricultural Science
Geography, Physics and Economics.
Agricultural Engineering (AE)
SSCE Requirements
To study this course, candidates seeking admission into the Agricultural Engineering (AE) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Any one other subject from:
Introduction to Agricultural Science,
Materials and Workshop Process and Machining,
Tractor Layout Power Unit Under Carriage and Auto Electricity;
Transmission System;
Implement and Machine;
Principles of Crop Husbandry and Land Use,
Materials and Workshop Processes;
Construction and Maintenance of Agricultural Machines;
General Metal Work;
General Wood Work and Building / Engineering Drawing.
Nigerian Tertiary Institutions Offering Industrial Education Technology Course