If you are planning to study Metallurgical and Material Engineering at Ronik Polytechnic, Ejigbo located in Lagos State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Ronik Polytechnic.
Does Ronik Polytechnic, Ejigbo offer Metallurgical and Material Engineering?
No, Ronik Polytechnic, Ejigbo does not offer Metallurgical and Material Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Ronik Polytechnic, Ejigbo below to check if the Metallurgical and Material Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Metallurgical and Material Engineering When Accredited in Ronik Polytechnic, Ejigbo
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Metallurgical and Material Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
one other Science subject.
Ronik Polytechnic Cut-Off Mark for Metallurgical and Material Engineering
The general UTME cut-off mark is 180, but due to the variation of Metallurgical and Material Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Ronik Polytechnic Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Ronik Polytechnic Science Courses with their Requirements
Computer Science (CS)
SSCE Requirements
To study this course, candidates seeking admission into the Computer Science (CS) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other Science subjects.
Electrical / Electronic Engineering Technology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Electrical / Electronic Engineering Technology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science Subject.
Statistics
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Statistics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other relevant subject.
Nigerian Tertiary Institutions Offering Metallurgical and Material Engineering Course