If you are planning to study Mechanical Engineering at St. Mary Polytechnic, Kwamba located in Niger State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into St. Mary Polytechnic.
Does St. Mary Polytechnic, Kwamba offer Mechanical Engineering?
No, St. Mary Polytechnic, Kwamba does not offer Mechanical Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at St. Mary Polytechnic, Kwamba below to check if the Mechanical Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechanical Engineering When Accredited in St. Mary Polytechnic, Kwamba
O’Level Requirements
To study this course, candidates aspiring to gain admission into Mechanical Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant Science subjects.
St. Mary Polytechnic Cut-Off Mark for Mechanical Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechanical Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from St. Mary Polytechnic Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other St. Mary Polytechnic Science Courses with their Requirements
Electrical / Electronic Engineering Technology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Electrical / Electronic Engineering Technology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science Subject.
Computer Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Computer Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Computer Science (CS)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Science (CS) department.
any two (2) other Science subjects.
Nigerian Tertiary Institutions Offering Mechanical Engineering Course