If you are planning to study Engineering Physics at Tansian University, Oba located in Anambra State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into TANU.
Does Tansian University (TANU), Oba offer Engineering Physics?
No, Tansian University, Oba does not offer Engineering Physics under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Tansian University (TANU), Oba below to check if the Engineering Physics course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Engineering Physics When Accredited in Tansian University (TANU), Oba
O’Level Requirements
To study this course, candidates seeking admission into the Engineering Physics department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any one (1) of Health Science, Statistics, Physics and Geography.
JAMB Subject Combination
either Physics or Mathematics.
TANU Cut-Off Mark for Engineering Physics
The general UTME cut-off mark is 180, but due to the variation of Engineering Physics cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from TANU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other TANU Science Courses with their Requirements
Education and Biology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Biology department.
Architecture
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Computer Science (CS)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Science (CS) department.
any two (2) other Science subjects.
Microbiology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Microbiology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Industrial Chemistry
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Industrial Chemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology / Agricultural Science.
Biology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Biology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Mathematics / Physics and
any one other relevant subject.
Chemistry
SSCE Requirements
To study this course, candidates aspiring to gain admission into Chemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Nigerian Tertiary Institutions Offering Engineering Physics Course