If you are planning to study Orthopaedic and Plaster Technology at The Polytechnic Otada Adoka located in Benue State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into Otada Adoka Polytechnic.
Does The Polytechnic Otada Adoka offer Orthopaedic and Plaster Technology?
No, The Polytechnic Otada Adoka does not offer Orthopaedic and Plaster Technology under its Faculty of Allied Health Sciences. However, since our course list is updated regularly, you can visit the courses available at The Polytechnic Otada Adoka below to check if the Orthopaedic and Plaster Technology course under the Faculty of Allied Health Sciences has been updated.
Admission Requirements for Orthopaedic and Plaster Technology When Accredited in The Polytechnic Otada Adoka
O’Level Requirements
To study this course, candidates seeking admission into the Orthopaedic and Plaster Technology department under Faculty of Allied Health Sciences, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Otada Adoka Polytechnic Cut-Off Mark for Orthopaedic and Plaster Technology
The general UTME cut-off mark is 230, but due to the variation of Orthopaedic and Plaster Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Otada Adoka Polytechnic Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Otada Adoka Polytechnic Science Courses with their Requirements
Statistics
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Statistics department.
any other relevant subject.
Electrical / Electronic Engineering Technology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Electrical / Electronic Engineering Technology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science Subject.
Computer Science (CS)
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Computer Science (CS) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other Science subjects.
Computer Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Computer Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Nigerian Tertiary Institutions Offering Orthopaedic and Plaster Technology Course