If you are planning to study Geology and Mineral Sciences at University of Benin located in Edo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNIBEN.
Does University of Benin (UNIBEN) offer Geology and Mineral Sciences?
No, University of Benin does not offer Geology and Mineral Sciences under its Faculty of Earth and Mineral Sciences. However, since our course list is updated regularly, you can visit the courses available at University of Benin (UNIBEN) below to check if the Geology and Mineral Sciences course under the Faculty of Earth and Mineral Sciences has been updated.
Admission Requirements for Geology and Mineral Sciences When Accredited in University of Benin (UNIBEN)
O’Level Requirements
To study this course, candidates seeking admission into the Geology and Mineral Sciences department under Faculty of Earth and Mineral Sciences, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
JAMB Subject Combination
Use of English and any three (3) of
UNIBEN Cut-Off Mark for Geology and Mineral Sciences
The general UTME cut-off mark is 180, but due to the variation of Geology and Mineral Sciences cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIBEN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIBEN Science Courses with their Requirements
Geology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Geology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other relevant subject.
Education and Integrated Science
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Education and Integrated Science department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Any other four (4) relevant subjects
Physical Education
SSCE Requirements
To study this course, candidates aspiring to gain admission into Physical Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology or its Equivalent,
any two (2) relevant subjects.
Science Laboratory Technology (SLT)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Science Laboratory Technology (SLT) department.
Any two (2) subjects from: Physics, Chemistry, and Biology / Agricultural Science / Health Science
Any other two (2) relevant subjects (Technical Drawing, Metal / Wood Work, Basic Electricity, Geography, Further Mathematics, and Fine Art)
Mechanical Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
Animal Science
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Animal Science department.
Biology / Agric Science, and
any one from Physics, Geography or Economics.
Architecture
SSCE Requirements
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Nigerian Tertiary Institutions Offering Geology and Mineral Sciences Course