If you are planning to study Applied Geology at University of Delta, Agbor located in Delta State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNIDEL.
Does University of Delta (UNIDEL), Agbor offer Applied Geology?
No, University of Delta, Agbor does not offer Applied Geology under its Faculty of Science. However, since our course list is updated regularly, you can visit the courses available at University of Delta (UNIDEL), Agbor below to check if the Applied Geology course under the Faculty of Science has been updated.
Admission Requirements for Applied Geology When Accredited in University of Delta (UNIDEL), Agbor
O’Level Requirements
To study this course, candidates seeking admission into the Applied Geology department under Faculty of Science, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
JAMB Subject Combination
Chemistry, Physics, Mathematics,
UNIDEL Cut-Off Mark for Applied Geology
The general UTME cut-off mark is 180, but due to the variation of Applied Geology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIDEL Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIDEL Science Courses with their Requirements
Mechanical Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
Architecture
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Marine Science and Technology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Marine Science and Technology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
two (2) other Science subject.
Education and Integrated Science
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Education and Integrated Science department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Any other four (4) relevant subjects
Biotechnology
SSCE Requirements
To study this course, candidates aspiring to gain admission into Biotechnology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Physical and Health Education
SSCE Requirements
To study this course, candidates seeking admission into the Physical and Health Education department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology or its equivalent
and any two (2) other relevant subjects.
Electrical / Electronics Engineering
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronics Engineering department.
any other Science subject.
Nigerian Tertiary Institutions Offering Applied Geology Course