If you are planning to study Auto and Mechanical Technology Education at University of Delta, Agbor located in Delta State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNIDEL.
Does University of Delta (UNIDEL), Agbor offer Auto and Mechanical Technology Education?
No, University of Delta, Agbor does not offer Auto and Mechanical Technology Education under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at University of Delta (UNIDEL), Agbor below to check if the Auto and Mechanical Technology Education course under the Faculty of Education has been updated.
Admission Requirements for Auto and Mechanical Technology Education When Accredited in University of Delta (UNIDEL), Agbor
O’Level Requirements
To study this course, candidates aspiring to gain admission into Auto and Mechanical Technology Education department under Faculty of Education, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any one (1) of Biology / Agricultural Science; Physics, or Chemistry,
Auto Technical, Technical Drawing / Fine Art, Geography, Health Science Food and Nutrition,
Physical and Health Education, General Science / Integrated Science, Building, Electrical Electronic, Metal Work and Wood Work.
UNIDEL Cut-Off Mark for Auto and Mechanical Technology Education
The general UTME cut-off mark is 180, but due to the variation of Auto and Mechanical Technology Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIDEL Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIDEL Science Courses with their Requirements
Chemistry
SSCE Requirements
To study this course, candidates seeking admission into the Chemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Architecture
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Architecture department.
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Microbiology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Microbiology department.
Mechanical Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Mechanical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other relevant Science subjects.
Agricultural Science and Education
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Agricultural Science and Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology/Agricultural Science,
any other relevant subject.
Physical and Health Education
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Physical and Health Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology or its equivalent
and any two (2) other relevant subjects.
Education and Integrated Science
SSCE Requirements
To study this course, candidates aspiring to gain admission into Education and Integrated Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Any other four (4) relevant subjects
Nigerian Tertiary Institutions Offering Auto and Mechanical Technology Education Course