If you are planning to study Polymer Engineering at University of Delta, Agbor located in Delta State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNIDEL.
Does University of Delta (UNIDEL), Agbor offer Polymer Engineering?
No, University of Delta, Agbor does not offer Polymer Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Delta (UNIDEL), Agbor below to check if the Polymer Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Polymer Engineering When Accredited in University of Delta (UNIDEL), Agbor
O’Level Requirements
To study this course, candidates aspiring to gain admission into Polymer Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
UNIDEL Cut-Off Mark for Polymer Engineering
The general UTME cut-off mark is 180, but due to the variation of Polymer Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIDEL Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIDEL Science Courses with their Requirements
Environmental Management and Toxicology
SSCE Requirements
To study this course, candidates seeking admission into the Environmental Management and Toxicology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Architecture
SSCE Requirements
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Education and Computer Science
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Education and Computer Science department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
three (3) other relevant Science subjects.
Statistics
SSCE Requirements
To study this course, candidates seeking admission into the Statistics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other relevant subject.
Mechatronics Engineering
SSCE Requirements
To study this course, candidates seeking admission into the Mechatronics Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
Urban and Regional Planning (URP)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Urban and Regional Planning (URP) department.
Physics, Chemistry, Economics, Government, Biology, Art, History, IRK/CRK, Social Studies and Tech Drawing.
Biology
SSCE Requirements
To study this course, candidates seeking admission into the Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Mathematics / Physics and
any one other relevant subject.
Nigerian Tertiary Institutions Offering Polymer Engineering Course