If you are planning to study Crop Production Technology at University of Ilorin located in Kwara State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNILORIN.
Does University of Ilorin (UNILORIN) offer Crop Production Technology?
No, University of Ilorin does not offer Crop Production Technology under its Faculty of Agriculture. However, since our course list is updated regularly, you can visit the courses available at University of Ilorin (UNILORIN) below to check if the Crop Production Technology course under the Faculty of Agriculture has been updated.
Admission Requirements for Crop Production Technology When Accredited in University of Ilorin (UNILORIN)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Crop Production Technology department under Faculty of Agriculture.
Biology/Agricultural Science,
one Science/Social Science subject and
at least a pass in Physics.
UNILORIN Cut-Off Mark for Crop Production Technology
The general UTME cut-off mark is 180, but due to the variation of Crop Production Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNILORIN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNILORIN Science Courses with their Requirements
Nursing (Science)
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Nursing (Science) department.
Architecture
SSCE Requirements
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Optometry
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Optometry department.
Physics, Chemistry, Biology and
Additional / Further Mathematics.
Education and Computer Science
SSCE Requirements
To study this course, candidates seeking admission into the Education and Computer Science department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
three (3) other relevant Science subjects.
Metallurgical and Material Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Metallurgical and Material Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
one other Science subject.
Agricultural Science and Education
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Agricultural Science and Education department.
Biology/Agricultural Science,
any other relevant subject.
Zoology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Zoology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subject.
Nigerian Tertiary Institutions Offering Crop Production Technology Course