If you are planning to study Mechanical and Metallurgical Engineering at University of Ilorin located in Kwara State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNILORIN.
Does University of Ilorin (UNILORIN) offer Mechanical and Metallurgical Engineering?
No, University of Ilorin does not offer Mechanical and Metallurgical Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Ilorin (UNILORIN) below to check if the Mechanical and Metallurgical Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechanical and Metallurgical Engineering When Accredited in University of Ilorin (UNILORIN)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Mechanical and Metallurgical Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
one (1) other Science subject.
UNILORIN Cut-Off Mark for Mechanical and Metallurgical Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechanical and Metallurgical Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNILORIN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNILORIN Science Courses with their Requirements
Technology Education
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Technology Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other three (3) relevant subjects.
Food Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Food Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Chemical Engineering
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Chemical Engineering department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
Health Education
SSCE Requirements
To study this course, candidates seeking admission into the Health Education department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant subjects.
Medicine and Surgery
SSCE Requirements
To study this course, candidates seeking admission into the Medicine and Surgery department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Electrical / Electronics Technology Education
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Electrical / Electronics Technology Education department.
any other Science subject.
Teacher Education Science
SSCE Requirements
To study this course, candidates aspiring to gain admission into Teacher Education Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant subjects.
Nigerian Tertiary Institutions Offering Mechanical and Metallurgical Engineering Course