If you are planning to study Education and Computer Science at Abia State University located in Abia State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into ABSU.
Does Abia State University (ABSU) offer Education and Computer Science?
No, Abia State University does not offer Education and Computer Science under its Faculty of Education. However, since our course list is updated regularly, you can visit the courses available at Abia State University (ABSU) below to check if the Education and Computer Science course under the Faculty of Education has been updated.
Admission Requirements for Education and Computer Science When Accredited in Abia State University (ABSU)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Education and Computer Science department under Faculty of Education, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
three (3) other relevant Science subjects.
JAMB Subject Combination
Biology, Chemistry, and Geography.
ABSU Cut-Off Mark for Education and Computer Science
The general UTME cut-off mark is 180, but due to the variation of Education and Computer Science cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from ABSU Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other ABSU Science Courses with their Requirements
1. Building Technology (BT)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Building Technology (BT) department.
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be; Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
2. Education and Mathematics
To study this course, candidates aspiring to gain admission into Education and Mathematics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
one (1) other Science subject, and
any other relevant subjects.
3. Education and Biology
To study this course, candidates seeking admission into the Education and Biology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
4. Pure and Industrial Physics
To study this course, candidates aspiring to gain admission into Pure and Industrial Physics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
one (1) other Science subject from:
Biology or Agricultural Science.
5. Crop Production and Protection
To study this course, candidates aspiring to gain admission into Crop Production and Protection department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology / Agricultural Science,
one Science/Social Science subject and
at least a pass in Physics.
6. Mechanical Engineering
To study this course, candidates seeking admission into the Mechanical Engineering department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant Science subjects.
7. Environmental Science
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Environmental Science department.
For holders of NTC, the relevant subjects could be;
General Wood work, Building / Engineering, Drawing, Introduction to Building Construction, Decorative Painting, Spray Painting, Lining, Sign and Design, Wall hanging, Colour Mixing / Matching and Glazing,
Printing Origination, Machine Printing and Finishing, General Metal Work, Basic Electricity, Spinning, Weaving, Surface Design and Printing, Bleaching, Dyeing and Finishing, Graphic Design, Graphic Printing and Ceramics.
Nigerian Universities Offering Education and Computer Science Course